HP Designjet T2300 eMFP Series - Using Your Product

5. Close the scanner cover and gently push it down to lock it into place.
6. Clean the area immediately in front of the scanner, where the scanned sheet rests before
scanning.
7. Reconnect the product's power cable, turn on the power switch at the rear, and turn on the
product using the Power key.
Replace the scanner’s glass plate
Over time, the condition of the glass plate can deteriorate. Small scratches on the surface of the glass
can reduce image quality. Contact HP Support (see
Contact HP Support on page 209) to order a new
glass plate.
1. Turn off the product using the Power key at the front, then also turn off the power switch at the rear
and disconnect the power cable.
2. There is a small lever at the rear left of the scanner. Slide the lever to the right and open the
scanner cover.
3. Remove the plastic insert.
4. Remove four small parts as shown.
158 Chapter 16 Maintaining the product ENWW