Installation Guide

◦ Mesa-libGL-devel required to install nbody after cuda tool kit installation:
– mesa-libGL-devel-7.11-5.el6.x86_64.rpm
◦ mcelog package to decode kernel machine check log on x86 machines used by CT
memory error check:
– mcelog-1.0pre3_20110718-0.14.el6.x86_64.rpm
◦ Install the following two font-related RPM packages from the respective DVD ISO
distribution.
– urw-fonts-2.4-10.el6.noarch.rpm
– ghostscript-fonts-5.50-23.1.el6.noarch.rpm
• RHEL 6.4 CT RPM Kit Dependent packages
tk:
– tk-8.5.7-5.el6.x86_64.rpm
◦
◦ OpenIPMI, ipmitool, net-snmp-libs, lm_sensors-libs (needed to start ipmi service):
OpenIPMI–2.0.16–14.el6.x86_64.rpm–
– OpenIPMI–libs–2.0.16–14.el6.x86_64.rpm
– ipmitool–1.8.11–13.el6.x86_64.rpm
– net–snmp–libs–5.5–44.el6.x86_64.rpm
– lm_sensors–libs–3.1.1–17.el6.x86_64.rpm
◦ libxml, libstdc++, zlib (32-bit [i686] RPMs needed for conrep):
libstdc++-4.4.7–3.el6.i686.rpm–
– libstdc++–devel–4.4.7–3.el6.x86_64.rpm
– libxml2–2.7.6–8.el6_3.4.i686.rpm
– zlib–1.2.3–29.el6.i686.rpm
◦ Mesa-libGL-devel required to install nbody after cuda tool kit installation:
mesa–libGL–9.0–0.7.el6.x86_64.rpm–
– mesa–libGL–devel–9.0–0.7.el6.x86_64.rpm
◦ mcelog package to decode kernel machine check log on x86 machines used by CT
memory error check:
– mcelog–1.0pre3_20120814_2–0.6.el6.x86_64.rpm
◦ Install the following two font-related RPM packages from the respective DVD ISO
distribution.
– urw–fonts–2.4–10.el6.noarch.rpm
– ghostscript–fonts–5.50–23.1.el6.noarch.rpm
◦ Other dependent packages that might be required (if not already installed):
– expect-5.44.1.15-4.el6.x86_64.rpm
– oddjob-0.30-5.el6.x86_64.rpm
– python-imaging-1.1.6-19.el6.x86_64.rpm
– telnet-0.17-47.el6_3.1.x86_64
8 Requirements and installation of CT RPM