Installation Guide

• RHEL 6.2 CT RPM Kit Dependent packages
tk:
– tk-8.5.7-5.el6.x86_64.rpm
◦
◦ OpenIPMI, ipmitool, net-snmp-libs, lm_sensors-libs (needed to start ipmi service):
OpenIPMI-2.0.16-12.el6.x86_64.rpm–
– OpenIPMI-libs-2.0.16-12.el6.x86_64.rpm
– ipmitool-1.8.11-12.el6.x86_64
– net-snmp-libs-5.5-37.el6.x86_64.rpm
– lm_sensors-libs-3.1.1-10.el6.x86_64.rpm
◦ libxml, libstdc++, zlib (32-Bit [i686]RPMs needed for conrep):
libstdc++-4.4.6-4.el6.i686.rpm–
– libxml2-2.7.6-4.el6.i686.rpm
– zlib-1.2.3-27.el6.i686.rpm
◦ Mesa-libGL-devel required to install nbody after cuda tool kit installation:
– mesa-libGL-devel-7.11-3.el6.x86_64.rpm
◦ mcelog package to decode kernel machine check log on x86 machines used by CT
memory error check:
– mcelog-1.0pre3_20110718-0.14.el6.x86_64.rpm
◦ Install the following two font-related RPM packages from the respective DVD ISO
distribution.
– urw-fonts-2.4-10.el6.noarch.rpm
– ghostscript-fonts-5.50-23.1.el6.noarch.rpm
• RHEL 6.3 CT RPM Kit Dependent packages
tk:
– tk-8.5.7-5.el6.x86_64.rpm
◦
◦ OpenIPMI, ipmitool, net-snmp-libs, lm_sensors-libs (needed to start ipmi service):
OpenIPMI-2.0.16-12.el6.x86_64.rpm–
– OpenIPMI-libs-2.0.16-12.el6.x86_64.rpm
– ipmitool-1.8.11-13.el6.x86_64.rpm
– net-snmp-libs-5.5-41.el6.x86_64.rpm
– lm_sensors-libs-3.1.1-10.el6.x86_64.rpm
◦ libxml, libstdc++, zlib (32-Bit [i686]RPMs needed for conrep):
libstdc++-4.4.5-6.el6.i686.rpm–
– libxml2-2.7.6-4.el6_2.4.i686.rpm
– zlib-1.2.3-27.el6.i686.rpm
Requirements for Cluster Test RPM 7