Installation Guide

• You should have access to the appropriate RPM package. Information on how to download
RPMs is available in the section “Getting the CT RPM kit” (page 15).
• Prerequisite OS RPMs:
xinetd◦
◦ openmpi (test binaries are built against openmpi-1.6.4)
◦ hphealth (Optional. Required to run Health Check.)
◦ hponcfg (Optional. Required to run Hardware and Firmware Summaries.)
• You should install the following RPMs from your OFED distribution if they are not already
installed:
◦ infiniband-diags
◦ libibmad1
• RHEL 6.1 CT RPM Kit Dependent packages
tk:
– tk-8.5.7-5.el6.x86_64.rpm
◦
◦ OpenIPMI, ipmitool, net-snmp-libs, lm_sensors-libs (needed to start ipmi service):
OpenIPMI-2.0.16-12.el6.x86_64.rpm–
– OpenIPMI-libs-2.0.16-12.el6.x86_64.rpm
– ipmitool-1.8.11-7.el6.x86_64.rpm
– net-snmp-libs-5.5-31.el6.x86_64.rpm
– lm_sensors-libs-3.1.1-10.el6.x86_64.rpm
◦ libxml, libstdc++, zlib (32–Bit [686]RPMs needed for conrep):
libstdc++-4.4.5-6.el6.i686.rpm–
– libxml2-2.7.6-1.el6.i686.rpm
– zlib-1.2.3-25.el6.i686.rpm
◦ Mesa-libGL-devel required to install nbody after cuda tool kit installation:
– mesa-libGL-devel-7.10-1.el6.x86_64.rpm
◦ mcelog package to decode kernel machine check log on x86 machines used by CT
memory error check:
– mcelog-1.0pre3_20110718-0.14.el6.x86_64.rpm
◦ Install the following two font-related RPM packages from the respective DVD ISO
distribution.
– urw-fonts-2.4-10.el6.noarch.rpm
– ghostscript-fonts-5.50-23.1.el6.noarch.rpm
6 Requirements and installation of CT RPM