Installation Guide

2 Installing HP 3PAR Cluster Extension Software
This chapter describes the installation of HP 3PAR Cluster Extension Software in Microsoft clustering
environments with HP 3PAR storage systems.
NOTE:
• You can install, uninstall, modify, and repair HP 3PAR Cluster Extension on all of the nodes
in a cluster by running the installer from one node in the cluster.
• For information on configuring HP 3PAR Cluster Extension in a Microsoft clustering environment,
see the HP 3PAR Cluster Extension Software Administrator Guide.
Prerequisites
Before installing HP 3PAR Cluster Extension, perform the following tasks:
1. Check “General installation prerequisites” (page 6) to ensure that your setup meets the
general pre-installation requirements.
2. Perform the required Windows pre-installation procedures. For instructions, see “Pre-installation
procedures” (page 8).
3. Download the HP 3PAR Cluster Extension Software installer.
a. Browse to https://h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?
productNumber=CLX.
b. Click HP Storage > Storage Software in the product category list.
c. Follow the on-screen instructions to download the installer.
Pre-installation procedures
This section describes the procedures you must perform to prepare the data centers for HP 3PAR
Cluster Extension installation and configuration. Perform these procedures before you install HP
3PAR Cluster Extension.
1. “Checking the IP network setup and SAN configuration” (page 8)
2. “Installing the multipath software” (page 9)
3. “Installing and configuring the JRE” (page 9)
4. “Installing HP 3PAR Command Line Interface (CLI)” (page 9)
5. “Configuring the HP 3PAR storage system” (page 9)
6. “Creating hosts and setting host persona” (page 9)
7. “Creating virtual volumes and adding a LUN presentation” (page 10)
8. “Creating Remote Copy volume groups” (page 10)
9. “Installing Microsoft Failover Cluster (MSFC) on all nodes” (page 10)
Checking the IP network setup and SAN configuration
Verify that your IP network setup and SAN configuration meet the following requirements:
• HP 3PAR Cluster Extension requires a cluster environment in which one location failure will
not cause the entire cluster to shut down.
• In a Node Majority quorum cluster, all nodes must be distributed so that an equal number of
nodes are located in the local and remote data centers and an additional node in a third
location functions as a tiebreaker or arbitrator.
The third location can be a separate room in a separate fire protection zone with separate
power connections. The arbitrator node can act as a regular cluster node and can be connected
8 Installing HP 3PAR Cluster Extension Software