Administrator's Guide

Table 1 Setting resource properties and values in the GUI
ValueDescriptionFormatProperty
GUI: 01:00 mm:ss (Default)
CLI: 60000 milliseconds
(Default)
Used to poll “Alive” state for
the resource. Also used by
HP 3PAR Cluster Extension
to perform HP 3PAR Remote
IntegerThorough Resource Health
Check Interval )
IsAlivePollInterval (CLI)
Copy start operations if
auto_recover policy is set
for a particular Remote
Copy volume group.
Decreasing this value allows
faster resource failure
detection but also consumes
more system resources.
Set this value in the
Advanced Policies tab of the
resource properties window
in Failover Cluster
Management.
GUI: 00:05 mm:ss (Default)Used to poll “Alive” state for
the resource. Decreasing this
IntegerBasic Resource Health Check
Interval )
CLI: 5000 milliseconds
(Default)
value allows for faster
resource failure detection but
LooksAlivePollInterval (CLI)
also consumes more system
resources.
Set this value in the
Advanced Policies tab of the
resource properties window
in Failover Cluster
Management.
0 (Required)Defines whether a resource
can be 0 (Required)
IntegerIf a resource fails, attempt
restart on current node –
automatically restarted after
it has failed.
Maximum restarts in the
specified period )
Set this value in the Policies
tab of the resource
RestartThreshold (CLI)
properties window in
Failover Cluster
Management.
Check (Required)Defines whether resources
will be failed over if a restart
is unsuccessful.
IntegerIf restart is unsuccessful, fail
over all resources in this
service or application
CLI: 2 restart and
affect the group
(Required)
Set this value in the Policies
tab of the resource
RestartAction (CLI)
properties window in
Failover Cluster
Management.
GUI: 15:00 mm:ss (Default)Determines the amount of
time for restart.
IntegerIf a resource fails, attempt
restart on current node –
Period for restarts
CLI: 900000 milliseconds
(Default)
Set this value in the Policies
tab of the resourceRestartPeriod (CLI)
properties window in
Failover Cluster
Management.
GUI: 03:00 mm:ssUsed to specify the timeout
for status resolution. For
IntegerPending timeout (GUI)
PendingTimeout (CLI)
CLI: 180000 milliseconds
(Default)
more information, see
“Timing considerations for
Setting Microsoft cluster-specific resource and service or application properties 25