White Paper

Configuring HP CloudSystem to Use a Remote Access Service to run workflows in HP Operations Orchestration
Enabling the new registered worker
When you log in to HP OO Central and access the
System Configuration
panel, you should see two
registered workers in the
Topology
section. There is a default Linux worker and the Windows RAS
worker you created in the previous steps.
Select the Windows RAS worker and then click the enable button ( ). At this point you can
execute workflows using the recently installed worker. Select the
Workflows
panel to run a specific
Windows workflow.
Some workflows require special setup on the target machine where it is executed. Make sure to
review the specific workflow requirements on each workflow description before running the flow.
Learn more about HP CloudSystem:
http://www.hp.com/go/CloudSystem and
http://www.hp.com/go/CloudSystem/docs
© Copyright 2014 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and
services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial
errors or omissions contained herein.
5900-3911, August 2014 5