Installation Guide

Procedure 15 Configure Enterprise to use the Foundation NTP servers for time sync
If you are using an ESX management hypervisor to mange the Enterprise appliance, then you will
need to perform the following procedure.
1. Enable the console user for the Enterprise appliance.
See appendix C, “Supported console operations on the CloudSystem Foundation appliance”
in the HP CloudSystem 8.0 Administrator Guide at the Enterprise Information Library.
2. Log in as cloudadmin through the Enterprise console. You can use CTRL+ALT+F1 to switch
to the console log in prompt.
3. Edit the NTP configuration file to add the server entries:
sudo vi/etc/ntp.conf
4. Restart the NTP service:
sudo service ntpd restart
5. Restart the Enterprise appliance.
See also: Refer to the HP CloudSystem 8.0 Administrator Guide at the Enterprise Information Library
for additional information on using HP CSA to create designs.
Next steps: See “Understanding CloudSystem Enterprise” in the HP CloudSystem 8.0 Administrator
Guide at Enterprise Information Library.
Installing the Enterprise appliance 51