Manualshelf

User's Manual

ManualsBrandsHP ManualsSoftwareHP Cloud Network Manager Software Series
41424344454647484950
Data pane item Description
SHAREDKEY Enter a shared key for communicating with the external RADIUS server.
RETYPE
SHAREDKEY
Re-enter the shared key.
TIMEOUT Specify a timeout value in seconds. The value determines the timeout for one
RADIUS request. The AP retries to send the request several times (as configured in
the Retry count), before the user is disconnected. For example, if the Timeout is 5
seconds, Retry counter is 3, user is disconnected after 20 seconds. The default
value is 5 seconds.
RETRY COUNT Specify a number between 1 and 5. Indicates the maximum number of
authentication requests that are sent to the server group. The default value is 3
requests.
RFC 3576 Select Enabled to allow the APs to process RFC 3576-compliant CoA and
disconnect messages from the RADIUS server. Disconnect messages terminate
the user session immediately, whereas the CoA messages modify session
authorization attributes such as data filters.
NAS IP ADDRESS Enter the VC IP address. The NAS IP address is the VC IP address that is sent in
data packets.
NOTE: If you do not enter the IP address, the VC IP address is used by default
when Dynamic RADIUS Proxy (DRP) is enabled.
NAS IDENTIFIER Use this to configure strings for RADIUS attribute 32, NAS Identifier, to be sent with
RADIUS requests to the RADIUS server.
DEAD TIME Specify a dead time for authentication server in minutes.
When two or more authentication servers are configured on the AP and a server is
unavailable, the dead time configuration determines the duration for which the
authentication server is available if the server is marked as unavailable.
DYNAMIC RADIUS
PROXY
PARAMETERS
Specify the following dynamic RADIUS proxy parameters:
l DRP IP — IP address to be used as source IP for RADIUS packets.
l DRP MASK — Subnet mask of the DRP IP address.
l DRP VLAN — VLAN in which the RADIUS packets are sent.
l DRP GATEWAY — Gateway IP address of the DRP VLAN.
For more information on dynamic RADIUS proxy parameters and configuration
procedure, see Configuring dynamic RADIUSproxy parameters on page 51.
n LDAP Server —To configure an LDAP server, specify the attributes described in the following table:
Data pane item Description
NAME Enter the name of the LDAP server.
IP ADDRESS Enter the IP address of the LDAP server.
AUTH PORT Enter the authorization port number of the LDAPserver. The default port number is
389.
Table 22: LDAPserver configuration parameters
HP Cloud Network Manager | User Guide Wireless configuration | 50