Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)
This example shows how to display the status of all the interfaces on the switch (some output has been removed
for brevity):
switch# show interface brief
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc3/1 1 auto on trunking swl TE 2 --
fc3/2 1 auto on sfpAbsent -- -- --
...
fc3/8 1 auto on sfpAbsent -- -- --
-------------------------------------------------------------------------------
Interface Status IP Address Speed MTU Port
Channel
-------------------------------------------------------------------------------
Ethernet1/1 hwFailure -- -- 1500 --
Ethernet1/2 hwFailure -- -- 1500 --
Ethernet1/3 up -- 10000 1500 --
...
Ethernet1/39 sfpIsAbsen -- -- 1500 --
Ethernet1/40 sfpIsAbsen -- -- 1500 --
-------------------------------------------------------------------------------
Interface Status IP Address Speed MTU
-------------------------------------------------------------------------------
mgmt0 up 172.16.24.41 100 1500
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
vfc 1 1 F -- down -- -- --
...
This example shows how to display the mapping between the VLANs and VSANs on the switch:
switch# show vlan fcoe
VLAN VSAN Status
-------- -------- --------
15 15 Operational
20 20 Operational
25 25 Operational
30 30 Non-operational
Mapping VSANs to VLANs Example Configuration
The following example shows how to configure the FCoE VLAN and a virtual Fibre Channel interface:
Procedure
Step 1
Configure the VLAN on a physical Ethernet address.
switch# configure terminal
switch(config)# interface ethernet 1/4
switch(config-if)# spanning-tree port type edge trunk
switch(config-if)# switchport mode trunk
switch(config-if)# switchport trunk allowed vlan 1,200
switch(config-if)# exit
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
416 OL-16597-01
Mapping VSANs to VLANs Example Configuration
Associating a Virtual Fibre Channel Interface to a VSAN