Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

You can add show commands only to full text and XML destination profiles. Short text destination profiles
do not support additional show commands because they only allow 128 bytes of text.
Related Topics
• Call Home Message Levels , page 352
Call Home Message Levels
Call Home allows you to filter messages based on their level of urgency. You can associate each destination
profile (predefined and user defined) with a Call Home message level threshold. The switch does not generate
any Call Home messages with a value lower than this threshold for the destination profile. The Call Home
message level ranges from 0 (lowest level of urgency) to 9 (highest level of urgency), and the default is 0 (
Cisco Nexus 5000 Series sends all messages).
Call Home messages that are sent for syslog alert groups have the syslog severity level mapped to the Call
Home message level.
Call Home does not change the syslog message level in the message text.Note
The following table lists each Call Home message level keyword and the corresponding syslog level for the
syslog port alert group.
Table 44: Severity and syslog Level Mapping
Descriptionsyslog LevelKeywordCall Home Level
Network-wide
catastrophic failure.
N/ACatastrophic9
Significant network
impact.
N/ADisaster8
System is unusable.Emergency (0)Fatal7
Critical conditions that
indicate that immediate
attention is needed.
Alert (1)Critical6
Major conditions.Critical (2)Major5
Minor conditions.Error (3)Minor4
Warning conditions.Warning (4)Warning3
Basic notification and
informational messages.
Notice (5)Notification2
Possibly independently
insignificant.
Normal event signifying
return to normal state.
Information (6)Normal1
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
352 OL-16597-01
Configuring Smart Call Home
Call Home Message Levels