Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes,Cisco NX-OS Release 5.1(3)N2(1a) and NX-OS Release 5.1(3)N2(1)

Send documentation comments to [e-mail]
3
Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, Cisco NX-OS Release 5.1(3)N2(1a) and NX-OS Release 5.1(3)N2(1)
OL-26652-02
System Requirements
Cisco Nexus 2000 Series Fabric Extenders
The Cisco Nexus 2000 Series Fabric Extender (FEX) is a highly scalable and flexible server networking
solution that works with the Cisco Nexus 5000 Series switches to provide high-density and low-cost
connectivity for server aggregation. Scaling across 1-Gigabit Ethernet, 10-Gigabit Ethernet, unified
fabric, rack, and blade server environments, the FEX is designed to simplify data center architecture and
operations.
The FEX integrates with its parent Cisco Nexus 5000 Series switch which allows zero-touch
provisioning and automatic configuration. The FEX provides a single point of management that supports
a large numbers of servers and hosts that can be configured with the same feature set as the parent Cisco
Nexus 5000 Series switch, including security and quality of service (QoS) configuration parameters.
Spanning Tree Protocol (STP) is not required between the Fabric Extender and its parent switch, because
the Fabric Extender and its parent switch allow you to enable a large multi-path, loop-free, active-active
topology.
Software is not included with the Fabric Extender. Cisco NX-OS software is automatically downloaded
and upgraded from its parent switch. For information about configuring the Cisco Nexus 2000 FEX, see
the “Configuring the Fabric Extender” chapter in the Cisco Nexus 5000 Series Layer 2 Switching
Configuration Guide.
System Requirements
This section includes the following topics:
• Hardware Supported, page 3
• Online Insertion and Removal Support, page 7
Hardware Supported
The Cisco NX-OS software supports the Cisco Nexus 5000 Series. You can find detailed information
about supported hardware in the Cisco Nexus 5000 Series Hardware Installation Guide.
Table 2 shows the hardware supported by Cisco NX-OS Release 5.1(x) software.
Table 2 Hardware Supported by Cisco NX-OS Release 5.1(x) Software
Cisco NX-OS Release Support
Hardware Part Number
5.1(3)N2(1a)
5.1(3)N2(1)
5.1(3)N1(1a)
5.1(3)N1(1)
5.0(3)N2(2a
)
5.0(3)N2(2)
5.0(3)N2(1) 5.0(3)N1(1) 5.0(2)N2(1) 5.0(2)N1(1)
Cisco Nexus 5000 Series
Cisco Nexus 5596UP
switch
N5K-C5596UP-FA X X X X — —
Cisco Nexus 5548UP
switch
N5K-C5548UP-FA X X X X — —
Cisco Nexus 5548P
switch
N5K-C5548P-FA X X X X X X