Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

Displaying SPAN Information
To display SPAN information, perform this task:
Procedure
PurposeCommand or Action
Displays the SPAN configuration.
switch# show monitor [session {all | session-number |
range session-range} [brief]]
Step 1
This example shows how to display SPAN session information:
switch# show monitor
SESSION STATE REASON DESCRIPTION
------- ----------- ---------------------- --------------------------------
2 up The session is up
3 down Session suspended
4 down No hardware resource
This example shows how to display SPAN session details:
switch# show monitor session 2
session 2
---------------
type : local
state : up
source intf :
rx : fc3/1
tx : fc3/1
both : fc3/1
source VLANs :
rx :
source VSANs :
rx : 1
destination ports : Eth3/1
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 679
Configuring SPAN
Displaying SPAN Information