Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

FCS Name Specification
You can specify if the unique name verification is for the entire fabric (globally) or only for locally (default)
registered platforms.
Set this command globally only if every switch in the fabric belong to the Cisco MDS 9000 Family or
Cisco Nexus 5000 Series of switches.
Note
To enable global checking of the platform name, perform this task:
To register platform attributes, perform this task:
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configuration terminal
Step 1
Enables global checking of the platform
name.
switch(config)# fcs plat-check-global vsan
vsan-id
Step 2
Disables (default) global checking of the
platform name.
switch(config)# no fcs plat-check-global vsan
vsan-id
Step 3
Displaying FCS Information
You can use the show fcs commands to display the status of the WWN configuration.
The following example shows how to display the FCS local database:
switch# show fcs database
The following example shows how to display a list of all interconnect elements for VSAN 1:
switch# show fcs ie vsan 1
The following example shows how to display information for a specific platform:
switch# show fcs platform name SamplePlatform vsan 1
The following example shows how to display port information for a specific pWWN:
switch# show fcs port pwwn 20:51:00:05:30:00:16:de vsan 24
Default FCS Settings
The following table lists the default FCS settings.
Table 98: Default FCS Settings
DefaultParameters
DisabledGlobal checking of the platform name
UnknownPlatform node type
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 663
Configuring Fabric Configuration Servers
FCS Name Specification