Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

PurposeCommand or Action
Enables the fcdomain configuration in the
specified VSAN.
switch(config)# fcdomain vsan vsan-id
Step 3
Configuring Fabric Names
To set the fabric name value for a disabled fcdomain, perform this task:
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configuration terminal
Step 1
Assigns the configured fabric name value in
the specified VSAN.
switch(config)# fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan vsan-id
Step 2
Changes the fabric name value to the factory
default (20:01:00:05:30:00:28:df) in VSAN
3010.
switch(config)# no fcdomain fabric-name
20:1:ac:16:5e:0:21:01 vsan vsan-id
Step 3
About Incoming RCFs
You can configure the rcf-reject option on a per-interface, per-VSAN basis. By default, the rcf-reject option
is disabled (that is, RCF request frames are not automatically rejected).
The rcf-reject option takes effect immediately.
No fcdomain restart is required.
You do not need to configure the RFC reject option on virtual Fibre Channel interfaces, because these
interfaces operate only in F port mode.
Note
Rejecting Incoming RCFs
To reject incoming RCF request frames, perform this task:
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configuration terminal
Step 1
Configures the specified interface.
switch(config)# interface fc slot/port
Step 2
Enables the RCF filter on the specified interface
in the specified VSAN.
switch(config-if)# fcdomain rcf-reject vsan
vsan-id
Step 3
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 483
Configuring Domain Parameters
Configuring Fabric Names