Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

The following example shows the interface display when showing the running configuration for a specific
interface:
switch# show running configuration fc3/5
interface fc3/5
switchport speed 2000
switchport mode E
channel-group 11 force
no shutdown
Verifying BB_Credit Information
The following example shows how to display the BB_credit information for all Fibre Channel interfaces:
switch# show interface bbcredit
...
fc2/3 is trunking
Transmit B2B Credit is 255
Receive B2B Credit is 12
Receive B2B Credit performance buffers is 375
12 receive B2B credit remaining
255 transmit B2B credit remaining
Default Fibre Channel Interface Settings
The following table lists the default settings for native Fibre Channel interface parameters.
Table 63: Default Native Fibre Channel Interface Parameters
DefaultParameters
AutoInterface mode
AutoInterface speed
Shutdown (unless changed during initial setup)Administrative state
On (unless changed during initial setup)Trunk mode
1 to 4093Trunk-allowed VSANs
Default VSAN (1)Interface VSAN
Off (disabled)Beacon mode
DisabledEISL encapsulation
2112 bytesData field size
The following table lists the default settings for virtual Fibre Channel interface parameters.
Table 64: Default Virtual Fibre Channel Interface Parameters
DefaultParameters
AutoInterface mode
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
476 OL-16597-01
Configuring Fibre Channel Interfaces
Verifying BB_Credit Information