Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

PurposeCommand
Displays the detailed configuration of the specified
Fibre Channel interface.
switch# show interface vfc vfc-id
Displays the status of all interfaces.switch# show interface brief
Displays the mapping of FCoE VLANs to VSANs.switch# show vlan fcoe
This example shows how to display a virtual Fibre Channel interface bound to an Ethernet interface:
switch# show interface vfc 3
vfc3 is up
Bound interface is Ethernet1/37
Hardware is Virtual Fibre Channel
Port WWN is 20:02:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is F, FCID is 0x490100
Port vsan is 931
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
Interface last changed at Thu May 21 04:44:42 2009
This example shows how to display a virtual Fibre Channel interface bound to a MAC address:
switch# show interface vfc 1001
vfc1001 is down
Bound MAC is 00:0a:00:00:00:01
Hardware is Virtual Fibre Channel
Port WWN is 23:e8:00:0d:ec:6d:95:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 901
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 415
Verifying the Virtual Interface
Associating a Virtual Fibre Channel Interface to a VSAN