Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

PurposeCommand or Action
This example shows how to set an interface to transmit LLDP packets:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# lldp transmit
This example shows how to configure an interface to disable LLDP:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# no lldp transmit
switch(config-if)# no lldp receive
Verifying FCoE Configuration
To verify FCoE configuration information, perform one of these tasks:
PurposeCommand
Displays whether FCoE is enabled on the switch.switch# show fcoe
Displays the contents of the FCoE database.switch# show fcoe database
Displays the FCoE settings for an interface or all
interfaces.
switch# show interface [interface number] fcoe
Displays LLDP configuration.switch# show lldp
This example shows how to verify that the FCoE capability is enabled:
switch# show fcoe
Global FCF details
FCF-MAC is 00:0d:ec:6d:95:00
FC-MAP is 0e:fc:00
FCF Priority is 128
FKA Advertisement period for FCF is 8 seconds
This example shows how to display the FCoE database:
switch# show fcoe database
-------------------------------------------------------------------------------
INTERFACE FCID PORT NAME MAC ADDRESS
-------------------------------------------------------------------------------
vfc3 0x490100 21:00:00:1b:32:0a:e7:b8 00:c0:dd:0e:5f:76
This example shows how to display the FCoE settings for an interface.
switch# show interface ethernet 1/37 fcoe
Ethernet1/37 is FCoE UP
vfc3 is Up
FCID is 0x490100
PWWN is 21:00:00:1b:32:0a:e7:b8
MAC addr is 00:c0:dd:0e:5f:76
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
408 OL-16597-01
Verifying FCoE Configuration
Configuring Interface LLDP Commands