Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

The following example shows how to configure a notification target user:
switch(config)# snmp-server user NMS auth sha abcd1234 priv abcdefgh engineID
00:00:00:63:00:01:00:a1:ac:15:10:03
Enabling SNMP Notifications
You can enable or disable notifications. If you do not specify a notification name, Cisco NX-OS enables all
notifications.
The snmp-server enable traps CLI command enables both traps and informs, depending on the configured
notification host receivers.
Note
The following table lists the CLI commands that enable the notifications for Cisco NX-OS MIBs.
Table 52: Enabling SNMP Notifications
Related CommandsMIB
snmp-server enable trapsAll notifications
snmp-server enable traps aaaCISCO-AAA-SERVER-MIB
snmp-server enable traps entityENITY-MIB,
CISCO-ENTITY-FRU-CONTROL-MIB,
CISCO-ENTITY-SENSOR-MIB
snmp-server enable traps entity fru
snmp-server enable traps licenseCISCO-LICENSE-MGR-MIB
snmp-server enable traps linkIF-MIB
snmp-server enable traps port-securityCISCO-PSM-MIB
snmp-server enable traps snmpSNMPv2-MIB
snmp-server enable traps snmp authentication
snmp-server enable traps fccCISCO-FCC-MIB
snmp-server enable traps fcdomainCISCO-DM-MIB
snmp-server enable traps fcnsCISCO-NS-MIB
snmp-server enable traps fcs discovery-completeCISCO-FCS-MIB
snmp-server enable traps fcs request-reject
snmp-server enable traps fdmiCISCO-FDMI-MIB
snmp-server enable traps fspfCISCO-FSPF-MIB
snmp-server enable traps port-securityCISCO-PSM-MIB
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
382 OL-16597-01
Configuring SNMP
Enabling SNMP Notifications