Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

PurposeCommand
Enables Call Home. Disabled by default.switch(config-callhome)# enable
You can disable Call Home in the callhome configuration mode.
PurposeCommand
Disables Call Home. Disabled by defaultswitch(config-callhome)# no enable
You can enable Call Home distribution using CFS in the callhome configuration mode.
PurposeCommand
Enables Call Home distribution using CFS. Disabled
by default.
switch(config-callhome)# distribute
You can commit Call Home configuration changes and distribute using CFS in the callhome configuration
mode.
PurposeCommand
Commits Call Home configuration changes and
distributes the changes to call CFS-enabled devices.
switch(config-callhome)# commit
You can discard Call Home configuration changes and release the CFS lock in callhome configuration mode.
PurposeCommand
Discards Call Home configuration changes and
releases the CFS lock. Use this command if you are
switch(config-callhome)# abort
the CFS lock owner or if you are logged into the
device that holds the CFS lock
Testing Call Home Communications
You can generate a test message to test your Call Home communications.
PurposeCommand
Sends the specified Call Home test message to all
configured destinations.
switch(config-callhome)# callhome send diagnostic
Sends a test message to all configured destinations.switch(config-callhome)# callhome test
callhome test and callhome test inventory
commands are supported.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 361
Configuring Smart Call Home
Testing Call Home Communications