Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

Configuring Online Diagnostics
You can configure the bootup diagnostics to run the complete set of tests, or you can bypass all bootup
diagnostic tests for a faster module boot up time.
We recommend that you set the bootup online diagnostics level to complete. We do not recommend
bypassing the bootup online diagnostics.
Note
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configure terminal
Step 1
Configures the bootup diagnostic level to trigger
diagnostics when the device boots, as follows:
switch(config)# diagnostic bootup
level [complete | bypass]
Step 2
• complete—Performs all bootup diagnostics. This is
the default value.
• bypass—Does not perform any bootup diagnostics.
(Optional)
Displays the bootup diagnostic level (bypass or complete)
that is currently in place on the switch.
switch# show diagnostic bootup
level
Step 3
The following example shows how to configure the bootup diagnostics level to trigger the complete diagnostics:
switch# configure terminal
switch(config)# diagnostic bootup level complete
Verifying Online Diagnostics Configuration
To display online diagnostics configuration information, perform one of the following tasks:
PurposeCommand
Displays the bootup diagnostics level.show diagnostic bootup level
Displays the results of the diagnostics tests.
show diagnostic result module slot
Default GOLD Settings
The following table lists the default settings for online diagnostics parameters.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
332 OL-16597-01
Configuring Online Diagnostics
Expansion Module Diagnostics