Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

Verifying a Session
To verify a session, use the following command in session mode:
PurposeCommand
Verifies the commands in the configuration session.switch(config-s)# verify [verbose]
Committing a Session
To commit a session, use the following command in session mode:
PurposeCommand
Commits the commands in the configuration session.switch(config-s)# commit [verbose]
Saving a Session
To save a session, use the following command in session mode:
PurposeCommand
(Optional) Saves the session to a file. The location
can be in bootflash or volatile.
switch(config-s)# save location
Discarding a Session
To discard a session, use the following command in session mode:
PurposeCommand
Discards the configuration session without applying
the commands.
switch(config-s)# abort
Session Manager Example Configuration
This example shows how to create a configuration session for ACLs:
switch# configure session name test2
switch(config-s)# ip access-list acl2
switch(config-s-acl)# permit tcp any any
switch(config-s-acl)# exit
switch(config-s)# interface Ethernet 1/4
switch(config-s-ip)# ip port access-group acl2 in
switch(config-s-ip)# exit
switch(config-s)# verify
switch(config-s)# exit
switch# show configuration session test2
Verifying Session Manager Configuration
To verify Session Manager configuration information, use the following commands:
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 327
Configuring Session Manager
Verifying a Session