Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

This example shows how to configure a vPC peer link:
switch# configure terminal
switch(config)# vpc domain 5
switch(config-if)# role priority 4000
Verifying the vPC Configuration
Use the following commands to display vPC configuration information:
PurposeCommand
Displays whether vPC is enabled or not.switch# show feature
Displays how many EtherChannels are configured
and how many are still available on the switch.
switch# show port-channel capacity
Displays running configuration information for vPCs.switch# show running-config vpc
Displays brief information on the vPCs.switch# show vpc brief
Displays the status of those parameters that must be
consistent across all vPC interfaces.
switch# show vpc consistency-parameters
Displays information on the peer-keepalive messages.switch# show vpc peer-keepalive
Displays the peer status, the role of the local switch,
the vPC system MAC address and system priority,
switch# show vpc role
and the MAC address and priority for the local vPC
switch.
Displays statistics on the vPCs.switch# show vpc statistics
This command displays the vPC statistics
only for the vPC peer device that you are
working on.
Note
For detailed information about the fields in the output from these commands, see the Cisco Nexus 5000 Series
Command Reference.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
144 OL-16597-01
Verifying the vPC Configuration
Manually Configuring a vPC Peer Switch Role