Cisco Nexus 5000 Series Switch CLI Software Configuration Guide (OL-16597-01, July 2009)

The following example shows how to enable 802.1Q tagging on the switch:
switch# configure terminal
switch(config)# vlan dot1q tag native
switch(config)# exit
switch# show vlan dot1q tag native
vlan dot1q native tag is enabled
Verifying Interface Configuration
To display access and trunk interface configuration information, perform one of these tasks:
PurposeCommand
Displays the interface configurationswitch# show interface
Displays information for all Ethernet interfaces,
including access and trunk interfaces.
switch# show interface switchport
Displays interface configuration information.switch# show interface brief
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01 109
Verifying Interface Configuration
Configuring Native 802.1Q VLANs