Cisco Nexus 5000 Series Release Notes for Release 5.0(3)N2(2) (June 2011)

Send documentation comments to [e-mail]
22
Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, for Cisco NX-OS Release 5.0(3)N2(2) and Release 5.0(3)N2(1)
Caveats
CSCti34155 The output for the show run ipqos all command does not show the default queuing
class map.
CSCti61513 The match ip rtp command is not supported in the match-all class.
Configuration Rollback
CSCti77835 A rollback fails to revert to the earlier VLAN configuration.
CSCti87532 A rollback fails when changes are made in the buffer-size for class-fcoe.
CSCti97003 A rollback fails and the output of the show rollback log exec command displays
"Deletion of switch profile failed".
CSCtj16996 A rollback fails when the switch profile configuration involves a conditional feature.
System Management
CSCsm03765 You cannot assign an IP address on the mgmt0 interface using Device Manager.
CSCso74872 When two SNMP walks are started simultaneously, one of them may fail with the
following error - 'OID not increasing'.
CSCsq57558 The software does not support an EISL encapsulation on an SD port (VFT cannot
be preserved).
CSCsq76688 A CDP neighbor is not removed immediately after the port is shut down.
CSCsq90423 In NPV mode, EISL encapsulation for an SD port is not supported.
CSCsr68690 When egress SPAN is configured on a port that is transmitting jumbo or large
frames, the spanned frames are truncated to 2384 bytes.
CSCsx40562 When using a FEX, the ACL drop traffic is not reaching the SPAN destination in
certain configuration cases.
CSCsx59489 When the switch and FEX bootup after entering the reload all command, the time
of event for any environment call home event, such as temperature alarm, power
supply or fan alarms, is set to 1970.
CSCsz81365 Even after private-vlan mapping is removed on a trunk port using the no switchport
private-vlan mapping trunk command, traffic received over the VLAN continues
to be SPANed.
CSCtb53820 The monitor session goes to the error state with VSAN as a source after a reload.
CSCtb84512 In a mixed SPAN mode where Ethernet port channels, vFCs, and FC ports are span
sources and an Ethernet interface is a SPAN destination, a vFC flap causes the traffic
coming in on the Ethernet port channel not to be spanned.
CSCtb94310 Removing or adding a SAN port member causes a monitor session to go into an error
state.
CSCtf32340 An error occurs while changing the VSAN and Interface scope of an existing role
name.
CSCti10941 The destination port is wrong in the show interface brief command output.
CSCtj53287 Traffic received over Fibre Channel ports cannot be monitored on SPAN.
Table 6 Cisco NX-OS Release 5.0(3)N2(1) and Release 5.0(3)N2(2) Open Caveats (continued)
Record Number Open Caveat Headline