Cisco Nexus 5000 Series Command Reference, Release 4.1(3)N1(1) (OL-16599-01, August 2009)

Send comments to [e-mail]
5-14
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 5 Quality of Service Commands
match protocol
match protocol
To configure a class map to use a specific protocol as a match criterion, use the match protocol
command. To remove the specified protocol as a match criteria, use the no form of this command.
match [not] protocol protocol-name
no match [not] protocol protocol-name
Syntax Description
Defaults None
Command Modes Class-map type qos configuration
Command History
Usage Guidelines The list of valid protocol names is shown in Table 3.
Note A maximum of eight different of the above protocols can be matched at one time.
not (Optional) Negates the specified match result.
protocol-name Matches on the specified protocol name. Valid values are shown in
Table 3.
Release Modification
4.1(3)N1(1) This command was introduced.
Table 3 Protocol Names
Argument Description
arp Address Resolution Protocol (ARP)
bridging Bridging
cdp Cisco Discovery Protocol (CDP)
clns Connectionless Network Service (CLNS)
clns_es CLNS End Systems
clns_is CLNS Intermediate System
dhcp Dynamic Host Configuration (DHCP)
isis Intermediate system to intermediate system
(IS-IS)
ldp Label Distribution Protocol (LDP)
netbios NetBIOS Extended User Interface (NetBEUI)