Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes,Cisco NX-OS Release 5.1(3)N2(1a) and NX-OS Release 5.1(3)N2(1)

Send documentation comments to [e-mail]
19
Cisco Nexus 5000 Series and Cisco Nexus 2000 Series Release Notes, Cisco NX-OS Release 5.1(3)N2(1a) and NX-OS Release 5.1(3)N2(1)
OL-26652-02
Caveats
Resolved Caveats—Cisco NX-OS Release 5.1(3)N2(1a)
Table 6 lists the caveats that are resolved in Cisco NX-OS Release 5.1(3)N2(1a) . The caveats may be
open in previous Cisco NX-OS releases.
Resolved Caveats—Cisco NX-OS Release 5.1(3)N2(1)
Table 7 lists the caveats that are resolved in Cisco NX-OS Release 5.1(3)N2(1). The caveats may be open
in previous Cisco NX-OS releases.
Table 6 Cisco NX-OS Release 5.1(3)N2(1a) Resolved Caveats
Record Number Resolved Caveat Headline
CSCty07729 Custom Perl scripts can cause the Cisco Nexus 5000 Series switch to fail with kernel
panic.
CSCty59143 After switch restore from reload, the port-channel status is down even though the
members are up.
CSCty83483 Traffic traversing the peer-link on a Cisco Nexus 5000 Series switch may be dropped.
CSCty86545 Private VLAN isolated trunk mode to a Cisco Nexus 5000 Series switch does not
work after upgrade.
CSCtz00790 After reloading a Nexus 55xx UP switch, eight consecutive ports may start dropping
all ingress traffic.
CSCtz13307 A Cisco Nexus 5500 Series switch running NX-OS 5.1(3)N1(1) might reload with
kernel panic.
CSCtz15346 The directory /mnt/pss grows too large and has no free space.
CSCtz33023 ISSU from 5.1(3)N1(1a) to N2(1) performed with CSCty59143 causes the
port-channels to go down.
CSCtz42084 SNMPWalk entPhysicalName for Cisco Nexus 5000 Series switch temperature sensor
returns incomplete value.
CSCtz89173 Whenever the type N2248TP-E command is entered under FEX, it is displayed as
N2348GTP.
CSCua21174 Priority Flow Control (PFC) stops working after upgrade.
Table 7 Cisco NX-OS Release 5.1(3)N2(1) Resolved Caveats
Record Number Resolved Caveat Headline
CSCti10941 SPAN destination port shows wrongly in the show int brief command.
CSCtl87260 The switch profile removal option should not impact the running configuration.
CSCtl94228 No IP load sharing not reset to default mode.
CSCtn31018 On an ST host interface port, the channel-grp command gets an error due to “slot
in vPC A-A mode.”
CSCtr73654 Peer ports go to UDLD error disabled when a module is powered off.
CSCtu14476 The insert-before option in a COPP customized policy should be removed.
CSCtu25289 RACLs on a subinterface are not applied following the copy startup-config
running-config command.