HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE-TE, December 2006)

Figure 38 Sele cting Load B alance Policy
7. Repeat steps 3 through 6 for the other target.
8. On the iSCSI-enabled C-Series Fibre Channel switch in the IP > iSCSI window , click the Session
Initiato
rs tab to verify C -Series iSCSI sessions (Figure 39).
Figure 39 Verifyin g C-Series iSCSI sessions
Configuring p-Class Blade servers in an iSCSI environment
This section describes the procedures to prepare a p-Class Blade server for inclusion in an iSCSI
environment. Each Blade server enclosure has a pair of network interconnects located at the left most and
right most positions in the enclosure. They transmit and receive all Ethernet and Fibre Channel signals
between installed Blade servers. The interconnect modules are based on either the Cisco Gigabit Ethernet
Switch Module (C GESM) or the Gibabit Ethernet 2 (GbE2) standards.
Configuring p-Class Blade CGESM server enclosure interconnects
This section describes a configuration example using CG ESM interconnects. For details on the
configuration or installation of the interconnects, see the specific Blade server documentation.
42