Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-199
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message MODULE-2-MOD_REGFAILED: Registration failed for module [dec].
Explanation
The module sent the registration message notifying a failure.
Recommended Action Collect module information by entering the show module internal all module
CLI command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] reported failure on ports
[dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]).
Explanation
Module reported a failure in the runtime diagnostic because of a failure in some of the
ports.
Recommended Action Collect module information by entering the show module internal all module
CLI command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 2.0(1b).
Error Message MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not
supported.
Explanation
The software card ID of module [dec] is not supported by the supervisor.
Recommended Action Collect module information by entering the show module internal all module
[dec] command or by using a similar Fabric Manager procedure. Update SPROM contents by
entering the update sprom command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported failure
on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device
error [hex]).
Explanation
The xbar in the slot reported a failure in the runtime diagnostic. Module manager is
going to power cycle the module.
Recommended Action Collect information about the module by issuing the show module internal
all xbar CLI command or by using a similar Fabric Manager procedure.'
Introduced Cisco MDS SAN-OS Release 3.0(1).
Error Message MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars])
failed.
Explanation
Xbar reported a failure during the initialization phase and will be powered down.
Recommended Action Collect information about the module by issuing the show module internal
all xbar <modulenumber> CLI command or by using a similar Fabric Manager procedure.
Introduced Cisco MDS SAN-OS Release 3.0(1).