Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 6.2(1) (OL-29201-01, April 12, 2013)

Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 6.2(1)

OL-29201-01

Related Documentation

Workaround: Reload the MSM-18/4 module in the same slot/module where the modflash mount

failed. A request will be sent to the supervisor to mount the modflash.

• CSCty82821

Symptom: After creating an SME cluster, adding disks to a disk group, changing some disk states,

and starting master key rekey, the key creation date is invalid.

Workaround: None.

• CSCuf54635

Symptom: When both the Enterprise Package and the Mainframe Package licenses are installed and

the fabric binding feature is enabled, the standby supervisor module goes into a failure state.

Workaround: None.

• CSCuf64822

Symptom: The DCBX local information shows LLS DCBX registration when a port is in the shut

state:

Local DCBXP Control information:

Operation version: 00 Max version: 00 Seq no: 1 Ack no: 0

Type/

Subtype Version En/Will/Adv Config

006/001 000 Y/N/Y 80

In this example 006/001 is the LLS TLV.

Usually all the other DCBX features are deregistered on a port down and this symptom is not seen

in the DCBX output. However, the LLS is not deregistered when a port is shut, and therefore it keeps

appearing in the output.

Workaround: None.

• CSCug14717

Symptom: If beaconing is configured on some ports, they might stop blinking after a supervisor

switchover or module reload.

This symptom might be seen following a supervisor switchover or module reload.

Workaround: None

• CSCuf35479

Symptom: The “Bad IPv6 host address” error appears when the snmp-server hostname is configured

instead of the IP address. This issue occurs when the domain name and the name-server IP address

are configured.

Workaround: Configure the IP addresses instead of the host name.