Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 6.2(1) (OL-29201-01, April 12, 2013)

Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 6.2(1)

OL-29201-01

Caveats

–

The performance statistics of such an FC IP tunnel are then collected with a tool such as Device

Manager. These steps cause extra memory on the module to be consumed, but that memory is

required for the ISSU or ISSD.

The preconditions of an ISSU or ISSD failure are satisfied when the 4th column of the following

command shows less than 26500 blocks available:

slot <DS-X9304-18K9_slot_#> show system internal flash | include roots

Workaround: This issue is resolved.

• CSCue92054

Symptom: The IVR feature checks out the SAN_EXT_FCIP license without checking to find out if

out if the SAN_EXT_FCIP license is checked out by the FC IP feature in Cisco NX-OS Release

5.2(x).

If the IVR feature is enabled first and it checks out the SAN_EXT_FCIP license, FC IP cannot check

out the license.

In Cisco NX-OS software releases earlier than Release 5.2(x), when the FC IP feature was enabled,

the FC IP module used the SAN-EXT license. If IVR was enabled after the FC IP feature was

enabled, IVR checked to find out if the SAN-EXT license was checked out by another feature. If it

was checked out, IVR could be enabled.

In Cisco NX-OS Release 5.2(x), after a switchover or ISSU from an earlier release, IVR checks out

the SAN_EXT license, and FC IP cannot use the SAN_EXT license because it is checked out by

IVR.

Workaround: This issue is resolved.

• CSCud49969

Symptom: If you enter the isapi health-check command after attaching the Cisco MDS 9000

18/4-Port Multiservice Module (MSM-18/4), the following error appears:

Memory Status: ERROR

Conditions: This symptom might be seen after attaching the MSM-18/4 module and entering the

isapi health-check command. The output shows “Memory Status: ERROR.”

Workaround: This issue is resolved.

Open Caveats

• CSCug01540

Symptom: The VSH process fails when the line length is greater than 471 characters.

Workaround: None.

• CSCug13649

Symptom: Bootflash files cannot be copied from the switch to the TFTP server using Device

Manager.

This symptom might be seen on the Cisco MDS 9513. When it occurs, SNMP immediately returns

14 (deviceBusy). When it occurs on the Cisco MDS 9710, SNMP immediately returns 2 (success).

Workaround: Copy the bootflash files from the switch to the TFTP server for Cisco MDS 9500

Series switches and the Cisco MDS 9710, as in the following example.