HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE-TE, December 2006)

Figure 29 Discovery Dynamic check box
3. Select the Node Address Persistent check box (Figure 30).
4. Select the N
ode Address System Assigned check box (Figure 30).
Figure 30 Nod e Add ress Persistent and Node Address System As signed ch eck
boxes
5. Click Apply.
6. Close the IP iSCSI window.
7. Select Admin > Save Configuration from the Device Manager menu bar.
8. Configure transparent-mode static mapping on both iSCSI-enabled C-Series switches.
Zoning the iSCSI Initiator and Fibre Channel storage WWPNs
The unique W WPN of the iSCSI Initiator acts as a virtual Fibre Channel host available o n the Fibre
Channel SAN. The WWPN is zoned with Fibre Channel storage as if it were a Fibre Channel HBA.
Creating zones
Use either the Fabric Manager or the switch CLI to create and modify SAN zones. HP recommends
creating separate iSCSI zones that contain the iSCSI WWPNs and the storage WWPNs that they access.
See the Cisco configuration documentation for information on creating, modif ying, or activating SAN
zones. Figure 31 shows an iSCSI Initiator zoned with an Enterprise Virtual Array storage port.
36