Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
16-12
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 16 Configuring and Managing Zones
Zone Sets
Step 5 Click Add to add the member to the zone.
Note When configuring a zone member, you can specify that a single LUN has multiple IDs depending
on the operating system. You can select from six different operating systems.
Configuring the Default Zone Policy
To permit or deny traffic in the default zone using Fabric Manager, perform this task:
Step 1 Choose Zone > Edit Local Full Zone Database.
You see the Select VSAN dialog box.
Step 2 Choose a VSAN and click OK.
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Step 3 Choose Edit > Edit Default Zone Attributes to configure the default zone QoS priority attributes.
You see the Modify Default Zone Properties dialog box as shown in Figure 16-12.
Figure 16-12 Modify Default Zone Properties Dialog Box
Step 4
Set the Policy drop-down list to permit to permit traffic in the default zone, or set it to deny to block
traffic in the default zone.
Step 5 Click OK to save these changes.
Zone Sets
This section describes zone sets and includes the following topics:
• About Zone Set Creation, page 16-13
• Activating a Zone Set, page 16-13
• Displaying Zone Membership Information, page 16-15
• About the Default Zone, page 16-16
• Configuring the Default Zone, page 16-16