Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide (OL-7765-06, November 2007)

Send documentation comments to [e-mail]
B-1
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
OL-7765-06
APPENDIX
B
Quick Config Wizard
As of Cisco SAN-OS Release 3.1(1) and later, you can use the Quick Config Wizard on the Cisco MDS
9124 Switch to add or remove zone members per VSAN. You can use the Quick Config Wizard to
perform interface-based zoning and to assign zone members for multiple VSANs using Device Manager.
Note The Quick Config Wizard is supported on the Cisco MDS 9124 Switch only.
Caution The Quick Config Wizard can only be used on stand-alone switches that do not have any existing zoning
defined on the switch.
Adding or Removing Zone Ports
To add or remove ports from a zone and to zone only the devices within a specific VSAN using Device
Manager on the Cisco MDS 9124 Switch, follow these steps:
Step 1 Select Quick Config from the FC menu or click the Zone icon in the toolbar.
You see the Quick Config Wizard (see Figure B-2) with all controls disabled and the Discrepancies
dialog box (see Figure B-1), which shows all unsupported configurations.
Note You will see the Discrepancies dialog box only if there are any discrepancies.