HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE-TE, December 2006)

About this guide
This guide describes the basic setup and configu ration for iSCSI using the C-Series I P Storage Ser vices
Modules (IPS-4, IPS-8), Multi-protocol Services Module (14/2), or MDS 9216i Fibre Channel switch.
This section describes the following topics:
•Configuration guide information
• Intended audience
• Related documentation
Configuratio
n guide information
This guide co
vers the following topics:
• Using the C-Series IP Storage Services Modules, Multi-Protocol Services Module and MDS 9216i
switch
• Hardware an
d software support
•Config uration constraints
•Configuring C-Series IP Storage Services Modules, Multi-protocol Services Module and MDS
9216i swit
ch in an HP Fibre Channel SAN
Intended audience
This document is intended for customers who have purchased an IP Storage Ser vices Modules (IPS-4,
IPS-8), Multi-protocol Services Module (14/2), or MDS 9216i switch and are planning to use the iSCSI
functionality in these products.
This document assumes a thorough understanding of HP Fibre Channel storage networking products,
including Fibre Channel switches and storage, as well as a basic understanding of TCP/IP networking.
Related do cumentation
Refer to
the following Cisco documentation for more information:
• Cisco® MDS 9000 Family Command Reference Guide
• Cisco MDS 9000 Family Fabric Manager Configuration Guide
• Cisco MD
S 9000 Family Soft ware Configuration Guide
Additi
onal documentation is available a t the following HP web site:
h
ttp:/
/h1800 6.w ww1 .hp.com/storage/sanin frastructure.html
On the H
P Storage SAN Infrastructure webpage, scroll to the C-Series Fabric section.
C-Series iSCSI 9