HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7PE-TE, December 2006)

Figure 33 Create iSC S I Targets wind ow
8. Click Create.
9. Select Admin > Save Configuration from the Device Manager menu bar.
Repeat all of the above steps for the other C-Series switch.
The iSCSI-enabled C-Series Fibre Channel switch setup is now complete.
Creating an iSCSI host
The host iSCSI Initiator must log in to the EVA storage controller before LUNs may be created.
Initial iSCSI Initiator EVA login
The iSCSI Initiator must log in to the storage controller so that the EVA storage controller can recognize
the iSCSI Initiator’s WWPN. By setting the controller port as a persistent target, the iSCSI Initiator will
reconnect to the storage controller after a power cycle or reboot.
1. From the Microsoft iSCSI Initiator Properties window’s Targets tab, click Refresh (Figure 34).
Thetwovirtualtargetsarelisted(oneforeachC-Seriesswitch).
38