Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-18
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message BOOTVAR-5-AUTOCOPY_VERIFY_SEND_FAILED: Unable to ask standby to
verify file [chars], error = [hex].
Explanation After copying the image to the standby supervisor, the active supervisor failed to verify
the integrity of that image on the standby supervisor.
Recommended Action Turn auto-copy off and back on.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message BOOTVAR-5-AUTOSYNC_DONE: Image autosync done.
Explanation
The image synchronization was done successfully.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message BOOTVAR-5-AUTOSYNC_REBOOT: Rebooting standby after successful
autosync.
Explanation
Image automatic synchronization was successful. The system is resetting the standby
supervisor to load the new image.
Recommended Action Verify that the standby supervisor reloads correctly.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message BOOTVAR-5-AUTOSYNC_START: Starting image autosync. Please wait until
completion.
Explanation
The standby supervisor has requested a synchronization of the current image.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message BOOTVAR-5-IMAGE_NOTEXISTS: Warning: image [chars] doesn’t exist on
sup[dec].
Explanation
The input image name does not exist on the specified supervisor.
Recommended Action Check whether the input image name you entered exists and make sure that
you have the image on the flash before reboot.
Introduced Cisco MDS SAN-OS Release 2.0(1b).
Error Message BOOTVAR-5-NEIGHBOR_UPDATE_AUTOCOPY: auto-copy supported by opposing
supervisor, starting...
Explanation
The standby supervisor supports automatic copy. Automatic copy has started.
Recommended Action No action is required.