Cisco MDS 9000 Family System Messages Reference (OL-15956-01, April 20078)

Send documentation comments to [e-mail]
2-379
Cisco MDS 9000 Family System Messages Reference
OL-15956-01
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
Error Message SYSMGR-2-VOLATILE_DB_FULL: System volatile database usage is
unexpectedly high at [dec]%
Explanation System volatile database space is almost full.
Recommended Action Issue the system pss shrink CLI command. If this message continues, contact
your technical support representative.
Introduced Cisco MDS SAN-OS Release 3.0(1).
Error Message SYSMGR-2-WARMSWITCHOVER_START: This supervisor is becoming active.
Explanation
A cold switchover has started.
Recommended Action When the other supervisor is back online, enter the show system reset-reason
CLI command or use a similar Fabric Manager/Device Manager procedure to find out what caused
the switchover.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message SYSMGR-2-WDT_KGDB: System watchdog kgdb has been [chars] for slot
[dec].
Explanation
System watchdog kgdb has been [chars]. If the command has been enabled, the system
will go into kgdb if there is a watchdog timeout.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 3.2(1).
SYSMGR-3
Error Message SYSMGR-3-CAPABILITY_REDUN_CHANGE: Redundancy mode changed to [chars]
due to configuration change.
Explanation
Some configuration changes have occurred causing the administrative redundancy
mode to change.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Error Message SYSMGR-3-CFGERASE_FAILED: Configuration erase failed (error-id [hex]).
Explanation
The requested configuration erase has failed. The error message shows the error ID
representing the failure reason.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).