Cisco Nexus 5000 Series Release Notes Release 4.0(1a)N1(1a) (OL-16601-01 G0, April 2009)

Send documentation comments to [e-mail]
7
Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a)
OL-16601-01
Release 4.0(1a)N1(1a) Upgrade and Downgrade Issues
When an Ethernet interface joins a EtherChannel, the following interface level parameters are disabled:
bandwidth Set bandwidth informational parameter
delay Specify interface throughput delay
duplex Enter the port duplex mode
flowcontrol Configure interface flowcontrol
ip Configure IP features
ipv6 Configure IPv6 features
mac MAC configuration commands
priority-flow-control Configure interface priority-flowcontrol
service-policy Configure QoS service policy
spanning-tree Spanning Tree Subsystem
speed Enter the port speed
storm-control Configure Interface storm control
Fibre Channel Port Shutdown
The following table describes the changes to the interface shutdown command syntax.
Switched Port Analyzer (SPAN)
The following table describes the changes to SPAN sessions.
4.0(0)-based
releases
The system default switchport shutdown command causes all Fibre Channel ports,
virtual or physical, to default to shutdown.
4.0(1a)N1(1a) The system default switchport shutdown command now configures the
administrative state for all Ethernet ports as down. To configure the Fibre Channel
ports to shutdown state, use the system default switchport shutdown san command.
Upgrade Ethernet ports will default to shutdown instead of Fibre Channel ports.
Downgrade This capability needs to be reconfigured after the downgrade. Otherwise, the switch
will flag the system default switchport shutdown san command as invalid.
4.0(0)-based
releases
The default is to keep session in an open state. To shut a session, use the following
command:
switch(config)# monitor session session-number suspend
4.0(1a)N1(1a) The default is to keep session state shut. To open a session, use the following
command:
switch(config)# no monitor session session-number shut
Note The syntax of the command has also changed. The suspend keyword has been
changed to shut.
Upgrade SPAN session will be in shut state after the upgrade.
Downgrade If you do not execute a specific shut or no-shut command on the SPAN session, the
SPAN session will be in a no suspend state after the downgrade.