Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2(1) (OL-16599-01, March 2009)

Send comments to [e-mail]
8-149
Cisco Nexus 5000 Series Command Reference
OL-16599-01
Chapter 8 Fibre Channel Commands
zone default-zone
zone default-zone
To define whether a default zone (assigned to nodes not assigned to a created zone) permits or denies
access to all nodes in the default zone, use the zone default-zone command. Use the no form of the
command to negate the command or revert to the factory defaults.
zone default-zone permit vsan vsan-id
no zone default-zone permit vsan vsan-id
Syntax Description
Command Default All default zones are permitted access.
Command Modes Configuration mode
Command History
Usage Guidelines Use the zone default-zone permit vsan command to define the operational values for the default zone
in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been
created.
Use the system default zone default-zone permit command to use the default values defined for the
default zone for all VSANs. The default values are used when you initially create a VSAN and it
becomes active.
Examples The following example permits default zoning in VSAN 2:
switch(config)# zone default-zone permit vsan 2
Related Commands
permit Permits access to all nodes in the default zone.
vsan vsan-id Sets default zoning behavior for the specified VSAN. The ID of the VSAN
is from 1 to 4093.
Release Modification
4.0(0)N1(1a) This command was introduced.
Command Description
system default zone
default-zone permit
Configures default values for a zone.
show zone Displays zone information.