Release Notes for the Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later

26
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later
OL-27316-02
Resolved Caveats
Caveats Resolved in Cisco IOS Release 15.0(2)SE
• CSCto78529
After upgrading to Cisco IOS Release 12.2(58)SE1, the Fa0 port on the switch does not respond to
the ping command.
The workaround is to use Cisco IOS Release 12.2(55)SE.
• CSCtq38500
When an interface is configured with the mls qos command, traffic is not matched by port-based
QoS ACLs that use the range option.
The workaround is to is to configure the switch using the single port eq keyword. Alternatively, you
can configure the trust under class-default setting for the same policy-map that uses the acl-range
option.
• CSCtq51049
In a switch stack, you cannot establish a console session with a member switch when an ACL is
applied to the VTY lines.
The workaround is to use the following procedure when you apply an ACL to line vty 0 4 and
line
vty 5 15:
1. Create the vty ACL and permit the 127 network.
2. Append the vrf-also keyword to the configured access-class inbound.
See the following example:
ip access-list standard vty-acl
permit 127.0.0.0 0.0.0.255
line vty 0 4
access-class vty-acl in vrf-also
privilege level 15
length 0
transport input ssh
line vty 5 15
access-class vty-acl in vrf-also
privilege level 15
transport input ssh
• CSCtr07908
The archive download feature does not work if the flash contains an “update” directory. This
situation is likely to occur if a previous download failed or was interrupted and the “update””
directory is still left in the flash.
The workaround is to delete the “update” directory in the flash before starting the archive download.
• CSCtr44361
When a device is moved from one port to another in a switch stack, the SNMP data generated for
the move event is incorrect.
The workaround is to ensure that the uplink to the core network is configured on the master switch
(for example, a 1/0/x port).
• CSCtr55645
OSPFv3 neighbors might flap because of the way the switch handles IPv6 traffic destined for
well-known IPv6 multicast addresses.