Release Notes for the Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later

Table Of Contents

Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later

OL-27316-02

Limitations and Restrictions

You should review this section before you begin working with the switch. These are known limitations

that will not be fixed, and there is not always a workaround. Some features might not work as

documented, and some features could be affected by recent changes to the switch hardware or software.

• Cisco IOS Limitations, page 10

• Device Manager Limitations, page 17

Cisco IOS Limitations

• Access Control List, page 10

• Address Resolution Protocol, page 11

• Cisco X2 Transceiver Modules and SFP Modules, page 11

• Configuration, page 11

• EtherChannel, page 12

• HSRP, page 13

• IEEE 802.1x Authentication, page 13

• Multicasting, page 14

• Quality of Service (QoS), page 15

• RADIUS, page 15

• Routing, page 15

• SPAN and RSPAN, page 16

• Stacking, page 16

• VLANs, page 17

Access Control List

• The Cisco Catalyst 3120 for HP Blade Switch has 964 TCAM entries available for ACLs in the

default and routing SDM templates instead of the 1024 entries that are available on the

Catalyst

3560 and Catalyst 3750 switches.

There is no workaround. (CSCse33114)

• When a MAC access list is used to block packets from a specific source MAC address, that MAC

address is entered in the switch MAC-address table.

The workaround is to block traffic from the specific MAC address by using the mac address-table

static mac-addr vlan vlan-id drop global configuration command. (CSCse73823)