Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

OL-22860-04

Related Documentation

Deleted System Messages

Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the 802.1X

action.

Explanation

The system memory is not sufficient to perform the IEEE 802.1x authentication.

Recommended Action Reduce other system activity to reduce memory demands.

Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on

Interface [chars]

Explanation

Authentication was successful. [chars] is the interface.

Recommended Action No action is required.

Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on

[chars]

Explanation

The client MAC address could not be added to the MAC address table because the

hardware memory is full or the address is a secure address on another port. This message might

appear if IEEE 802.1x is enabled. [enet] is the client MAC address, and [chars] is the interface.

Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.

If the client address is on another port, remove it from that port.

Error Message SW_VLAN-4-VTP_USER_NOTIFICATION: VTP protocol user notification:

[chars].

Explanation

This message means that the VTP code encountered an unusual diagnostic situation.

[chars] is a description of the situation.

Recommended Action Find out more about the error by using the show tech-support privileged

EXEC command. Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, open a case with the TAC, or

contact your Cisco technical support representative, and provide the representative with the gathered

information.