Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

OL-22860-04

Documentation Updates

Error Message DOT1X_SWITCH-5-ERR_VLAN_ON_ROUTED_PORT: Attempt to assign VLAN [dec]

to routed 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign a VLAN to a supplicant on a routed port, which is not

allowed. [dec] is the VLAN ID, the first [chars] is the port, and the second [chars] is the session ID.

Recommended Action Either disable the VLAN assignment, or change the port type to a nonrouted

port.

Error Message DOT1X_SWITCH-5-ERR_VLAN_PROMISC_PORT: Attempt to assign VLAN [dec] to

promiscuous 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign a VLAN to a promiscuous IEEE 802.1x port, which is

not allowed. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.

Recommended Action Change the port mode so that it is no longer a promiscuous port, or change the

configuration so that no VLAN is assigned.

Error Message DOT1X_SWITCH-5-ERR_VLAN_RESERVED: Attempt to assign reserved VLAN

[dec] to 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign an invalid VLAN to an IEEE 802.1x port. The VLAN

specified is a reserved VLAN and cannot be assigned to this port. [dec] is the VLAN, the first [chars]

is the port, and the seconds [chars] is the session ID.

Recommended Action Assign a different VLAN.

Error Message DOT1X_SWITCH-5-ERR_VLAN_RSPAN: Attempt to assign RSPAN VLAN [dec] to

802.1x port [chars]. 802.1x is incompatible with RSPAN AuditSessionID [chars]

Explanation

Remote SPAN should not be enabled on a VLAN with IEEE 802.1x-enabled. [dec] is the

VLAN, the first [chars] is the port, and the second [chars] is the session ID.

Recommended Action Either disable remote SPAN configuration on the VLAN, or disable IEEE

802.1x on all the ports in this VLAN.

Error Message SPANTREE-2-BLOCK_BPDUGUARD_VP: Received BPDU on port [chars], vlan

[dec] with BPDU Guard enabled. Disabling vlan.

Explanation

A BPDU was received on the interface and the VLAN specified in the error message.

The spanning tree BPDU guard feature was enabled and configured to shut down the VLAN. As a

result, the VLAN was placed in the error-disabled state. [chars] is the interface, and [dec] is the

VLAN.

Recommended Action Either remove the device sending BPDUs, or disable the BPDU guard feature.

The BPDU guard feature can be locally configured on the interface or globally configured on all ports

that have Port Fast enabled. Re-enable the interface and vlan by entering the clear errdisable

privileged EXEC command.