Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

36
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later
OL-22860-04
Documentation Updates
Error Message DOT1X_SWITCH-5-ERR_SPAN_DST_PORT: Attempt to assign VLAN [dec] to
802.1x port [chars], which is configured as a SPAN destination AuditSessionID
[chars]
Explanation
An attempt was made to assign a VLAN to an 802.1x port that is configured as a
Switched Port Analyzer (SPAN) destination port. [dec] is the VLAN, the first [chars] is the port, and
the second [chars] is the session ID.
Recommended Action Change the SPAN configuration so that the port is no longer a SPAN destination
port, or change the configuration so that no VLAN is assigned.
Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_MDA_INACTIVE: Multi-Domain Authentication
cannot activate because Data and Voice VLANs are the same on port AuditSessionID
[chars]
Explanation
Multi-Domain Authentication (MDA) host mode cannot start when the configured data
VLAN on a port is the same as the voice VLAN. [chars] is the port session ID.
Recommended Action Change either the voice VLAN or the access VLAN on the interface so that they
are not the same. MDA then starts.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INTERNAL: Attempt to assign internal VLAN
[dec] to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign an invalid VLAN to an 802.1x port. The VLAN specified
is used internally and cannot be assigned to this port. [dec] is the VLAN, the first [chars] is the port,
and the second [chars] is the session ID.
Recommended Action Assign a different VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INVALID: Attempt to assign invalid VLAN [dec]
to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign an invalid VLAN to an 802.1x port. The VLAN specified
is out of range. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session
ID.
Recommended Action Update the configuration to use a valid VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_NOT_FOUND: Attempt to assign non-existent or
shutdown VLAN [chars] to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign a VLAN to an 802.1x port, but the VLAN was not found
in the VLAN Trunking Protocol (VTP) database. [dec] is the VLAN, the first [chars] is the port, and
the second [chars] is the session ID.
Recommended Action Make sure the VLAN exists and is not shut down, or use another VLAN.