Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

OL-22860-04

Documentation Updates

Updates for the System Message Guide

New System Messages

Error Message AUTHMGR-5-SECURITY_VIOLATION: Security violation on the interface

[chars], new MAC address ([enet) is seen. AuditSessionID [chars]

Explanation

A host on the interface attempted to gain access to the network or attempted an

authentication. The interface mode does not support the number of hosts that are attached to the

interface. This is a security violation, and the interface has been error-disabled. The first [chars] is

the interface, [enet] is the Ethernet address of the host, and the second [chars] is the session ID.

Recommended Action Make sure that the interface is configured to support the number of hosts that

are attached to it. Enter the shutdown interface configuration command followed by no shutdown

interface configuration command to restart the interface.

Error Message AUTHMGR-5-VLANASSIGN: VLAN [dec] assigned to Interface [chars]

AuditSessionID [chars]

Explanation

A VLAN was assigned. [dec] is the VLAN ID, the first [chars] is the interface, and the

second [chars] is the session ID.

Recommended Action No action is required.

Error Message AUTHMGR-7-FAILOVER: Failing over from [chars] for client ([chars]) on

Interface [chars] AuditSessionID [chars]

Explanation

The authorization manager is failing over from the current authentication method to

another method. The first [chars] is the current authentication method, the second [chars] is the

client ID, the third [chars] is the interface, and the fourth [chars] is the session ID.

Recommended Action No action is required.

Error Message AUTHMGR-7-NOMOREMETHODS: Exhausted all authentication methods for

client ([chars]) on Interface [chars] AuditSessionID [chars]

Explanation

All available authentication methods have been tried for the client, but authentication has

failed. The first [chars] is the client ID, the second [chars] is the interface, and the third [chars] is the

session ID.

Recommended Action No action is required. If local authorization has been configured, the port will

be authorized based on the local authorization method. Otherwise, authentication will restart

according to the configured reauthentication period.