Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

30
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later
OL-22860-04
Documentation Updates
Documentation Updates
• Updates to the Software Configuration Guide, page 30
• Updates to the Switch Getting Started Guide, page 30
• Updates for the System Message Guide, page 31
Updates to the Software Configuration Guide
In the “Configuring RIP for IPv6” section in the “Configuring IPv6 Unicast Routing” chapter, the task
table is incorrect. This is the correct table:
Updates to the Switch Getting Started Guide
When you launch Express Setup, you are prompted for the switch password. Enter the default password,
cisco. The switch ignores text in the username field. Before you complete and exit Express Setup, you
must change the password from the default password, cisco.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ipv6 router rip name Configure an IPv6 RIP routing process, and enter router
configuration mode for the process.
Step 3
maximum-paths number-paths (Optional) Define the maximum number of equal-cost routes
that IPv6 RIP can support. The range is from 1 to 32, and the
default is 16 routes.
Step 4
exit Return to global configuration mode.
Step 5
interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step 6
ipv6 rip name enable Enable the specified IPv6 RIP routing process on the interface.
Step 7
ipv6 rip name default-information {only |
originate}
(Optional) Originate the IPv6 default route (::/0) into the RIP
routing process updates sent from the specified interface.
Note To avoid routing loops after the IPv6 default route (::/0)
is originated from any interface, the routing process
ignores all default routes received on any interface.
• only—Select to originate the default route, but suppress all
other routes in the updates sent on this interface.
• originate—Select to originate the default route in addition
to all other routes in the updates sent on this interface.
Step 8
end Return to privileged EXEC mode.
Step 9
show ipv6 rip [name] [database] [next-hops]
or
show ipv6 route rip [updated]
Display information about IPv6 RIP processes.
Display the contents of the IPv6 routing table.
Step 10
copy running-config startup-config (Optional) Save your entries in the configuration file.