Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

OL-22860-04

Important Notes

Device Manager Limitations

• When you are prompted to accept the security certificate and you click No, you only see a blank

screen, and the device manager does not start.

The workaround is to click Yes when you are prompted to accept the certificate. (CSCef45718)

• If you launch the device manager from a Firefox web browser, an invalid certificate alert appears.

If you launch the device manager from an Internet Explorer 7.0 browser, a certificate error appears.

The workaround when using Firefox is to either temporarily or permanently accept the certificate.

If you temporarily accept the certificate, close and then reopen the Firefox browser window. If you

permanently accept the certificate, delete the certificate, and then close and restart Firefox:

–

If you are using Firefox version 1.5, choose Tools > Options > Advanced > Security >

View Certificates > Web Sites, select the certificate, and click Delete.

–

If you are using Firefox version 2.0, choose Tools > Options > Advanced > Encryption > View

Certificates > Web Sites, select the certificate, and click Delete.

The workaround when using Internet Explorer is to click Click here for Options in the warning

message, and click Display Blocked Content. Close the browser window, and launch a new session.

(CSCsk80229)

Important Notes

• Cisco IOS Notes, page 17

• Device Manager Notes, page 18

Cisco IOS Notes

• If the switch requests information from the Cisco Secure Access Control Server (ACS) and the

message exchange times out because the server does not respond, a message similar to this appears:

00:02:57: %RADIUS-4-RADIUS_DEAD: RADIUS server 172.20.246.206:1645,1646 is not

responding.

If this message appears, make sure that there is network connectivity between the switch and the

ACS. You should also make sure that the switch has been properly configured as an AAA client on

the ACS.

• If the switch has interfaces with automatic QoS for voice over IP (VoIP) configured and you upgrade

the switch software to Cisco IOS Release 12.2(40)EX1 or later, when you enter the auto qos voip

cisco-phone interface configuration command on another interface, you might see this message:

AutoQoS Error: ciscophone input service policy was not properly applied

policy map AutoQoS-Police-CiscoPhone not configured

If this happens, enter the no auto qos voip cisco-phone interface command on all interfaces with

this configuration to delete it. Then enter the auto qos voip cisco-phone command on each of these

interfaces to reapply the configuration.