Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(46)SE

OL-16968-01

Documentation Updates

• CSCsq17094

Downstream switch interfaces in a link state group no longer fail under these conditions:

–

The switch is part of a stack.

–

There is a master switch over.

–

Some (or all) of the link state group interfaces are on the switch that becomes the new stack

master.

• CSCsr55949

When IEEE 802.1x is enabled on the switch, EAP notification packets are no longer dropped.

Documentation Updates

This information is added to the "Using Route Maps to Redistribute Routing Information" section in the

"Configuring IP Unicast Routing" chapter of the software configuration guide:

Note A route map with no set route-map configuration commands is sent to the CPU, which causes high CPU

utilization.

These system messages are not yet in the system message guide:

Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]

Explanation

The switch cannot create the specified managed object. [chars] is the object name.

Recommended Action No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]

informing virtual switches of dual-active: new active id [enet], old id [enet]

Explanation

Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,

which means that all virtual switches are in a dual-active scenario. The interface is informing virtual

switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first

[enet] is the new active ID. The second [enet] is the ID that it replaces.

Recommended Action No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]

registry

Explanation

The switch could not add a function to the registry. [chars] is the registry name.

Recommended Action No action is required.