Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(46)SE

OL-16968-01

Resolved Caveats

• CSCsj10198

When a per-port per-VLAN policy map (a hierarchical VLAN-based policy map) is attached to a

VLAN interface and you remove the child-policy policer from the policy map and then restore it,

the policy map now correctly re-attaches to the same SVI

• CSCsj77933

A space entered before a comma in the define interface-range or the interface range global

configuration command is now correctly saved in the switch configuration.

• CSCsk47893

A switch running the IP base image now supports full EIGRP stub routing.

• CSCsl72968

When multidomain authentication (MDA) is configured on a stack member, a switch port in that

stack is no longer intermittently enter disabled when the stack reloads.

• CSCso22855

If you specify the router ID before entering the autonomous-system autonomous-system-number

address-family configuration command, the router ID is no longer lost when the switch reloads.

• CSCso22883

Any form of the passive-interface command entered in one instance propagates to all configured

address-family instances for the same EIGRP routing process.

• CSCso66528

When an interface configured with port security reloads or you clear an error-disabled condition, the

interface no longer returns this traceback message:

%BIT-4-OUTOFRANGE: bit 0 is not in the expected range of 1 to 4095

• CSCso70893

A message similar to this one no longer appears when you log into a switch through an SSH session

and upgrade the switch by using the archive download-sw privileged EXEC command

*Mar 11 06:48:22.729 JST: %SCHED-3-THRASHING: Process thrashing on watched message

event. -Process= "SSH Process", ipl= 6, pid= 147

• CSCso72052

An end host no longer remains in the guest VLAN after IEEE 802.1X authentication.

• CSCso78837

When you use the clear counters privileged EXEC command to clear interface counters on a

port-channel interface, the show interfaces etherchannel privileged EXEC command output now

shows the correct number for received broadcast packets.

• CSCso81660

The show interfaces command output for a switch stack now shows the correct values for the output

drops.